Qume DataTrak 8 Manual descargar pdf (Pagina 34)

SECTION 3 CONSTRUCTION

[ ] Install a jumper wire from "CLK" to "5" in the

CLOCK SELECT BLOCK near ICs 2L-2M.

[ ] For use with a 16 bit address bus install a jumper

from "M" to "S" in the ADDRESS MODE JUMPER BLOCK. In

this mode IC 4B is not needed.

[ ] For use with a 24 bit address bus install a jumper

from "M" to "E" in the ADDRESS MODE JUMPED BLOCK. In

this mode IC 4B is required.

[ ] Insert the LM358 at U4. Insert the 74LSOO IC at 1D.

[ ] Insert the 74LS02 IC at 3C.

[ ] Insert the 74LS04 ICs at 1L and 2F.

[ ] Insert the 7406 ICs at 1M and 2H.

[ ] Insert the 74LS08 IC at 4A.

[ ] Insert the 74LS10 IC at 2E.

[ ] Insert the 74LS20 IC at 2C.

[ ] Insert the 74LS21 IC at 2B.

[ ] Insert the 74LS27 ICs at 3E and 3J.

[ ] Insert the 74LS32 IC at 3B.

[ ] Insert the 74LS74 IC at 2L.

[ ] Insert the 74LS93 IC at 2M.

[ ] Insert the 74LS113ICs at 1C and 3A.

[ ] Insert the 74LS123 ICs at 1A, 1B, 2A, OL, and OM.

[ ] Insert the 74L8240 ICs at 1F, 3K, and 3L.

[ ] Insert the 74LS24'4 ICs at 1H, 4F, 4H, 4J, 4K, and

4L.

[ ] Insert the 74LS273 IC at 4M.

[ ] Insert the 7425.ICs at 1k and 2K.

[ ] Insert the 7445 IC at 3M.

[ ] Insert the 8131 ICs at 3F and 3H.

Insert the 16-pin 150 ohm resistor pack at 1E.

[ ] Insert the Z80A microprocessor at 2D.

[ ] Insert the WD-1791-01 controller at 1J.

[ ] Insert the 21141-3 static rams at 4C, 4DL, 4DR, and

4E.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 46 47

Sin comentarios

Qume DataTrak 8 Manual Pagina 34